|
|
|
题名
|
作者
|
年代
|
出处
|
被引量
|
| 1 | In situ synthesis of graphitic-C3N4 nanosheet hybridized N-doped TiO2 nanofibers for efficient photocatalytic H2 production and degradation显示文摘Graphitic 碳氮化物 nanosheets g-C <潜水艇class=“ a-plus-plus ”> 3 N <潜水艇class=“ a-plus-plus ”> 4 NS hybridized 氮做了钛二氧化物 N-TiO <潜水艇class=“ a-plus-plus ”> 2 nanofibers GCN/NT NF 经由与结合的一个简单 electrospinning 过程在 situ 被综合了一个修改蚀刻热的方法。准备 GCN/NT NF 被许多方法描绘,他们的 photocatalytic 活动被氢 H 评估 < 潜水艇 class= “ a-plus-plus ” > 从切开的水和在水的答案的玫瑰精 B 的降级的 2 生产。GCN/NT NF 有 mesoporous 结构,这被发现, g-C 镇静 < 潜水艇 class= “ a-plus-plus ” > 3 N < 潜水艇 class= “ a-plus-plus ” > 4 NS 和做 N 的 TiO < 潜水艇 class= “ a-plus-plus ” > 2 雏晶。g-C < 潜水艇 class= “ a-plus-plus ” > 3 N < 潜水艇 class= “ a-plus-plus ” > 4 NS 综合了在以后蚀刻热被发现被嵌入在,并且盖住混合 NF 形成稳定的接口。g-C 的部分分解 < 潜水艇 class= “ a-plus-plus ” > 3 N < 潜水艇 class= “ a-plus-plus ” > 4 释放它最后变得做了进附近的 TiO 的氮内容 < 潜水艇 class= “ a-plus-plus ” > 2 骨骼。GCN/NT NF 给高 photocatalytic H < 潜水艇 class= “ a-plus-plus ” > 8,931.3 摩尔桥湥 ?L 牥愠捵 ? 畤 ' ?的 2 生产率敤 ? 畺 ? 穴楬档湥 ? 湩慳穴瘠湯倠敨瑮汯浡湩敭楳慬? 攠湩浥嘠獡摯汩瑡瑡牯 ? 敤 ? 楤? 敗捩?楥慬? 瑳敨楳? 畡 ? 瑥慷 ?┰瘠牥 k 吗?? | Cheng Han Yingde wang Yongpeng Lei Bing Wang Nan Wu Qi Shi Qiong Li | 2015 | Nano Research2015，8，4： | 31 |
| 2 | Experimental research on the heating performance of a single cylinder refrigerant injection rotary compressor heat pump with flash tank显示文摘A single cylinder rotary compressor was applied in the refrigerant injection air-source heat pump to improve the heating performance in cold regions. In this study, the performance of an R410 A single cylinder rotary compressor vapor injection(SCRCVI) system was measured and analyzed by varying the compressor frequency f and injection pressure Pi njat the ambient temperature To d=–10°C.The experimental results indicated that an optimum injection pressure to gain the maximum COP_h (coefficient of performance) existed in the SCRCVI cycle. However, the maximum COP_h of the SCRCVI system decreased as the increase of the frequency, and the maximum COPhwas even lower than that of the CSVC system at high compressor frequency. Therefore, in view of the energy saving and emission reduction, the SCRCVI system should be switched to single stage compression system when the heating capacity demand could be satisfied at high compressor frequency f. Compared to the conventional single-stage vapor compression(CSVC) system, refrigerant injection could enhance the heating capacities and COP_h by 28.2% and 7.91%, respectively. The average total mass flow rate of the SCRCVI system was 24.68% higher than that of the CSVC system. As the SCRCVI system worked at the optimum injection pressure, the variation trends of the different system parameters were investigated in detail. These trends were reliably used to optimize the refrigerant injection system design and the control strategy. The parameter of(P_(inj)–P_s) could be adopted as the signals to control the opening of the upper stage electronic expansion valve EEV1. | SUN JinFei ZHU DongSheng YIN YingDe LI XiuZhen | 2018 | Science China(Technological Sciences)2018，61，12： | 3 |
| 3 | Development of a laser capture microscope-based single-cell-type proteomics tool for studying proteomes of individual cell layers of plant roots显示文摘Single-cell-type proteomics provides the capability to revealing the genomic and proteomics information at cell-level resolution.However,the methodology for this type of research has not been well-developed.This paper reports developing a workflow of laser capture microdissection(LCM)followed by gel-liquid chromatography-tandem mass spectrometry(GeLC-MS/MS)-based proteomics analysis for the identification of proteomes contained in individual cell layers of tomato roots.Thin-sections(~10-μm thick,10 sections per root tip)were prepared for root tips of tomato germinating seedlings.Epidermal and cortical cells(5000–7000 cells per tissue type)were isolated under a LCM microscope.Proteins were isolated and then separated by SDS–polyacrylamide gel electrophoresis followed by in-gel-tryptic digestion.The MS and MS/MS spectra generated using nanoLC-MS/MS analysis of the tryptic peptides were searched against ITAG2.4 tomato protein database to identify proteins contained in each single-cell-type sample.Based on the biological functions,proteins with proven functions in root hair development were identified in epidermal cells but not in the cortical cells.Several of these proteins were found in Al-treated roots only.The results demonstrated that the cell-type-specific proteome is relevant for tissue-specific functions in tomato roots.Increasing the coverage of proteomes and reducing the inevitable cross-contamination from adjacent cell layers,in both vertical and cross directions when cells are isolated from slides prepared using intact root tips,are the major challenges using the technology in proteomics analysis of plant roots. | Yingde Zhu Hui Li Sarabjit Bhatti Suping Zhou Yong Yang Tara Fish Theodore W Thannhauser | 2016 | Horticulture Research2016，3，1： | 2 |
| 4 | Ag_(3)PO_(4) decorated black urchin-like defective TiO_(2) for rapid and long-term bacteria-killing under visible light显示文摘Both phototherapy via photocatalysts and physical puncture by artificial nanostructures are promising substitutes for antibiotics when treating drug-resistant bacterial infectious diseases.However,the photodynamic therapeutic efficacy of photocatalysts is seriously restricted by the rapid recombination of photogenerated electron-hole pairs.Meanwhile,the nanostructures of physical puncture are limited to two-dimensional(2D)platforms,and they cannot be fully used yet.Thus,this research developed a synergistic system of Ag_(3)PO_(4) nanoparticles(NPs),decorated with black urchin-like defective TiO_(2)(BU-TiO_(2-X)/Ag_(3)PO_(4)).These NPs had a decreased bandgap compared to BU-TiO_(2-X),and BU-TiO_(2)-X/Ag_(3)PO_(4)(3:1)exhibited the lowest bandgap and the highest separation efficiency for photogenerated electron-hole pairs.After combination with BU-TiO_(2-X),the photostability of Ag_(3)PO_(4) improved because the oxygen vacancy of BU-TiO_(2-X) retards the reduction of Ag^(+) in Ag_(3)PO_(4) into Ag^(0),thus reducing its toxicity.In addition,the nanospikes on the surface of BU-TiO_(2-X) can,from all directions,physically puncture bacterial cells,thus assisting the hybrid’s photodynamic therapeutic effects,alongside the small amount of Ag^(+) released from Ag_(3)PO_(4).This achieves synergy,endowing the hybrid with high antibacterial efficacy of 99.76±0.15%and 99.85±0.09%against Escherichia coli and Staphylococcus aureus,respectively,after light irradiation for 20 min followed by darkness for 12 h.It is anticipated that these findings may bring new insight for developing synergistic treatment strategies against bacterial infectious diseases or pathogenic bacterial polluted environments. | Yingde Xu Xiangmei Liu Yufeng Zheng Changyi Li Kelvin Wai Kwok Yeung Zhenduo Cui Yanqin Liang Zhaoyang Li Shengli Zhu Shuilin Wu | 2021 | Bioactive Materials2021，6，6： | 2 |
| 5 | 显示文摘 | Li Xinming Cui Yingde | 2008 | Chinese Journal of Chemical Engi- neering2008，16，4： | 1 |
| 6 | Modeling of mechanical properties of as-cast Mg-Li-Al alloys based on PSO-BP algorithm显示文摘Artificial neural networks have been widely used to predict the mechanical properties of alloys in material research.This study aims to investigate the implicit relationship between the compositions and mechanical properties of as-cast Mg-Li-Al alloys.Based on the experimental collection of the tensile strength and the elongation of representative Mg-Li-Al alloys,a momentum back-propagation(BP)neural network with a single hidden layer was established.Particle swarm optimization(PSO)was applied to optimize the BP model.In the neural network,the input variables were the contents of Mg,Li and Al,and the output variables were the tensile strength and the elongation. The results show that the proposed PSO-BP model can describe the quantitative relationship between the Mg-Li-Al alloy's composition and its mechanical properties.It is possible that the mechanical properties to be predicted without experiment by inputting the alloy composition into the trained network model.The prediction of the influence of Al addition on the mechanical properties of as-cast Mg-Li-Al alloys is consistent with the related research results. | Li Ming Hao Hai Zhang Aimin Song Yingde Liu Zhao Zhang Xingguo | 2012 | China Foundry2012，9，2： | 1 |
| 7 | Recent progress in all-inorganic metal halide nanostructured perovskites:Materials design,optical properties,and application显示文摘Low-dimensional all-inorganic metal halide perovskite(AIMHP)materials,as a new class of nanomaterials,hold great promise for various optoelectronic devices.In the past few years,tremendous progress has been achieved in the development of efficient and stable AIMHP nanomaterials for optical property studies and related applications.Here,we offer a critical overview on the unique merits and the state-of-the-art design of AIMHP using different composition strategies.Then,the effects of material compositions,dimensionality,morphologies and structures on optical properties are summarized.We also comprehensively present recent advances in the development AIMHP nanomaterials for practical applications including solar cells,light-emitting diodes,lasers and photodetectors.Lastly,the critical challenges and future opportunities in this emerging field are highlighted. | Lianzhen Cao Xia Liu Yingde Li Xiusheng Li Lena Du Shengyao Chen Shenlong Zhao Cong Wang | 2021 | Frontiers of physics2021，16，3： | 1 |
| 8 | Effects of Nd on microstructure and mechanical properties of as-cast Mg-8Li-3A1 alloy显示文摘 | Ming LI Hai HAO Aimin ZHANG Yingde SONG Xingguo ZHANG | 2012 | Journal of Rare Earths2012，，5： | 1 |
| 9 | P-T path of metamorphism and U-Pb monazite and zircon age of the Kitoy terrane: Implication for Neoarchean collision in SW Siberian Craton显示文摘The first data on P-T metamorphic conditions coupled with U-Pb monazite and zircon age obtained for the Neoarchean Kitoy granulite-gneiss terrane(SW Siberian Craton).Alumina gneisses of the Kitoy terrane indicate two-staged metamorphic evolution.The first stage of regional metamorphism(M1)occurred at high-amphibolite facies conditions at T=780-800℃ and P=8-9 kbar.The second stage(M2)belongs to MT-HT/LP type of metamorphism with the wide temperature interval 600-750℃ and pressure 2-4 kbar.Two age peaks were established on the basis of U-Pb monazite and zircon dating in garnet-anthophyllite gneisses.Both of them correspond to the Neoarchean age:the age of M1 falls into the interval of ca.2489-2496 Ma,the age of M2-ca.2446-2456 Ma.The high-temperature metamorphism of the Kitoy block and nearly coeval granitoid magmatism can be an evidence for the Neoarchean collision in SW Siberian craton. | Vasiliy P.Sukhorukov Valentina B.Savel’eva Yingde Jiang Zhiyong Li | 2020 | Geoscience Frontiers2020，11，6： | 0 |
| 10 | Origin and chronology for hornblende gabbroic intrusions in Urad Zhongqi of western Inner Mongolia and their tectonic implications显示文摘The Urad Zhongqi mafic intrusions crop out in western Inner Mongolia and are dominated by hornblende gabbro.Zircon LA-ICP-MS U-Pb dating indicates that the mafic pluton was emplaced in the Early Permian(272 ± 3Ma).The hornblende gabbro rocks have low concentrations of Si O2,high total Fe2O3,Mg O,Ni,Co,Sc and Cr.The rocks are characterized by selective enrichment of large ion lithophile elements(LILE) and light rare earth elements(LREE),and depletion in high field strength elements(HFSE)(e.g.Nb,Ta,Zr,Hf,P and Ti).It suggests that they formed from a primary magma generated by the partial melting of lithospheric mantle material had been previously modified by subduction-related fluids.According to the geochemical data and the geology of the region,the authors found that the Early Permian hornblende gabbroic in western Inner Mongolia formed in a post-collisional extensional setting. | WANG Yingde SUN Fengyue WANG Li ZHANG Gengxin LIU Jinlong Huo Liang | 2015 | Global Geology2015，18，2： | 0 |
您所在的机构暂未开通此部分的功能，请联系管理员